Configuring Ethernet Settings

 
Ethernet is a standard for communicating data in a local area network (LAN). You can set the communication mode (half-duplex/full-duplex) and the Ethernet type (10BASE-T/100BASE-TX/1000BASE-T). In general, the machine can be used without changing the defaults (Ethernet Driver), but you can change these settings to suit your network environment.
1
Press  ().
2
Use / to select <Network>, and press .
When a message appears, press .
3
Select <Ethernet Driver>  <Auto Detect>.
4
Select whether to configure Ethernet settings automatically or manually.
Configuring Ethernet settings automatically
Select <On> and press . The machine detects and automatically sets the communication mode and the Ethernet type that can be used.
Configuring Ethernet settings manually
1
Select <Off>, and press .
2
Select the communication mode.
Select <Communication Mode>    Select <Half Duplex> or <Full Duplex>  
 <Half Duplex>
Alternately sends and receives communication data. Select when the machine is connected to a networking device using half duplex.
 <Full Duplex>
Simultaneously sends and receives communication data. Use this setting for most environments.
3
Select the Ethernet type.
Select <Ethernet Type>    Select the Ethernet type  
When you select <1000 Base-T>, the setting for <Communication Mode> is changed to <Full Duplex>.
5
Perform a hard reset. Performing a Hard Reset
The settings are enabled after the hard reset is performed.
167A-03E